Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

iDRAC 8/7 v2.70.70.70 RACADM CLI Guide

PDF

getniccfg

Table 1. Details of getniccfg attributeThe following table provides details of getniccfg attribute:
Description

Displays the current and static NIC settings for iDRAC.

Displays the current NIC settings.

Synopsis
racadm getniccfg [-m <module>]
Input

–m <module> must be one of the following values:

  • chassis : Default state if -m is not specified.
  • server-<n> : where n=1–16
  • server-<nx> : where n=1–8; x = a, b, c, d (lower case)
  • switch-<n> : where n=1–6
Output

NOTE: :

Table 2. OutputThe getniccfg subcommand displays an appropriate error message if the operation is not successful. Otherwise, the output is displayed in the following format:
IPv4 settings:
NIC Enabled =1
IPv4 Enabled =1
DHCP Enabled =1
IP Address =10.94.225.165
Subnet Mask =255.255.255.128
Gateway =10.94.225.129
IPv6 settings:
IPv6 Enabled =1
DHCP6 Enabled =0
IP Address 1 =2000:de11:bcd1:fc14:1234:5678:2468:abcd
Gateway =::
Link Local Address =fe80::f21f:afff:fed0:82d6/64
IP Address 2 =::
IP Address 3 =::
IP Address 4 =::
IP Address 5 =::
IP Address 6 =::
IP Address 7 =::
IP Address 8 =::
IP Address 9 =::
IP Address 10 =::
IP Address 11 =::
IP Address 12 =::
IP Address 13 =::
IP Address 14 =::
IP Address 15 =::
LOM Status:
NIC Selection =dedicated
Link Detected =Yes
Speed =1Gb/s
Duplex Mode =Full Duplex
Active NIC =Dedicated
Static IPv4 settings:
Static IP Address =192.168.0.120
Static Subnet Mask =255.255.255.0
Static Gateway =192.168.0.1
Static IPv6 settings:
Static IP Address 1 =2000:de11:bcd1:fc14:1234:5678:2468:abcd/64
Static Prefix Length =64
Static Gateway =::
IPv6 information is displayed only if IPv6 is enabled in iDRAC.

NOTE: : IPv6 Address 1 field indicates static IP and IPv6 Address 2 field indicates dynamic IP.

NOTE: : LOM Status is displayed only for iDRAC on Rack and Tower servers and is not displayed for iDRAC Enterprise on Blade servers.

Example
  • Display CMC network settings
    racadm getniccfg -m chassis
    
  • Display iDRAC network settings in server slot 1
    racadm getniccfg -m server-1

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\