Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Installing the intrusion switch

Prerequisites

  1. Follow the safety guidelines listed in safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the front system cover.
  4. Remove the front drive cage .

Steps

  1. Align and insert the intrusion switch in the slot until it is firmly seated in the slot on the system.
    NOTE Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
  2. Replace the screws to secure the switch bracket to the chassis.
  3. Connect the intrusion switch cable to the connector on the system board.
    Figure 1. Front intrusion switch installation
    This image shows the front intrusion switch installation.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\