Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Installing the PERC riser

Prerequisites

  1. Follow the safety guidelines listed in safety instructions.
  2. Follow the procedure listed in the Before working inside your system.

Steps

  1. Holding the edges or the touch points, align the screw holes on the riser bracket with the screw hole on the expander module.
  2. Lower the PERC riser and press until the module clicks into place.
  3. Tighten the screw to secure the PERC riser to the expander module.
    Figure 1. Installing the PERC riser

    This image shows Installing the PERC riser.

Next steps

  1. Install the expander module.
  2. Follow the procedure listed in After working inside the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\