Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Installing the power distribution board

Prerequisites

WARNING Allow the power distribution board (PDB) to discharge after you power off the system. Handle the PDB by the edges and avoid touching the contact surfaces of the connectors.
  1. Follow the safety guidelines listed in safety instructions.

Steps

  1. Align the power distribution board (PDB) screw holes with bracket screw holes and insert the power distribution board into the bracket.
  2. Secure the PDB with the five screws.
  3. Connect the intrusion cable to the PDB.
    Figure 1. Installing the PDB

    This image shows Installing the PDB.

  4. Align and lower the PDB module into the chassis.
  5. Replace the two screws to secure the PDB module.
    Figure 2. Installing the PDB module

    This image shows Installing the PDB module.

Next steps

  1. close the rear system cover.
  2. Install the power supply units.
  3. Follow the procedure listed in After working inside the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\