Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Installing the sled (FWFH configuration)

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Hold the sled on both sides and slide the sled into the enclosure until the sled is locked to the enclosure.
  2. Push the sled lever under the sled and tighten the captive screws.
    Figure 1. Installing the sled
    This image shows installing the sled.
    NOTE The procedure to install the sled with FWLP configuration is same as the sled with FWFH configuration.

Next steps

  1. Follow the procedure listed in After working inside the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\