Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Removing a power supply unit

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Disconnect the power cable from the power source and from the PSU you intend to remove, and then remove the cable from the strap on the PSU handle.
CAUTION The power supply is only hot-swappable if you have a redundant system with two power supplies installed

Steps

  1. Press and hold the release latch.
  2. Slide the PSU out of the system using the PSU handle.
    Figure 1. Removing a power supply unit
    This image shows removing a power supply unit.

Next steps

Install the PSU

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\