Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Removing the 2.5-inch hard drive backplane

Prerequisites

CAUTION To prevent damage to the drives and backplane, you must remove the drives from the system before removing the backplane.
CAUTION You must note the slot number of each drive and temporarily label them before removal so that you can replace them in the same slots.
NOTE Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables properly when you replace them to prevent the cables from being pinched or crimped.
  1. Follow the safety guidelines listed in safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the expander module.
  4. Disconnect all the cables from the backplane.

Steps

  1. Using the Phillips #2 screwdriver, remove the two screws that secure the backplane to the expander module.
  2. Lift the backplane away from the expander module.
    Figure 1. Removing the backplane

    This image shows removing the backplane.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\