Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Removing the cooling fan cage

Prerequisites

WARNING Do not attempt to operate the system without the cooling fans.
WARNING The cooling fan spins for some time after the system is powered down. Allow the fan to stop spinning before removing it from the system.
NOTE Observe the routing of the cables when removing them from the system. Route these cables properly when you replace them to prevent the cables from being pinched or crimped.
  1. Follow the safety guidelines listed in safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the cooling fans.

Steps

  1. Remove the five screws securing the fan cage.
  2. Lift the cooling fan cage out of the chassis.
    Figure 1. Removing the cooling fan cage

    This image shows removing the cooling fan cage.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\