Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Removing the front intrusion switch

Prerequisites

  1. Follow the safety guidelines listed in safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the front system cover.
  4. Remove the front drive cage .

Steps

  1. Disconnect and remove the intrusion switch cable from the connector on the system board.

    Observe the routing of the cable as you remove it from the chassis.

  2. Remove the screws securing the switch bracket and move it away from the chassis.
  3. Remove the intrusion switch from the chassis.
    Figure 1. Front intrusion switch removal
    This image shows the front intrusion switch removal.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\