Dell EMC PowerEdge XE7100 Installation and Service Manual

PDF

Removing the power distribution board

Prerequisites

WARNING Allow the power distribution board (PDB) to discharge after you power off the system. Handle the PDB by the edges and avoid touching the contact surfaces of the connectors.
  1. Follow the safety guidelines listed in safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the power supply units.
  4. Open the rear system cover.

Steps

  1. Remove the two screws securing the power distribution board (PDB) module.
  2. Lift the PDB module and disconnect the intrusion cable.
    Figure 1. Removing the PDB module

    This image shows removing the PDB module.

  3. Remove the screws securing the PDB.
  4. Move the PDB away from the bracket.
    Figure 2. Removing the PDB

    This image shows removing the PDB.

Next steps

  1. Install the PDB.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\