Dell PowerEdge XE9685L Installation and Service Manual

PDF

Installing the intrusion switch module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the rear support bracket.
  4. Remove the air shroud.
  5. Remove the PSU.
  6. Observe and disconnect the cables from the connectors on the power distribution board.
  7. Remove the PSU cage.
NOTE:Ensure that you note the routing of the cable as you remove it from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.

Steps

  1. Align and slide the intrusion switch module into the slot in the system until firmly seated.
  2. Using a Phillips 1 screwdriver, tighten the screw on the intrusion switch module.
  3. Connect the intrusion switch cable to the connector on the rear I/O board.
    Figure 1. Installing the intrusion switch module
    This image shows Installing the intrusion switch module

Next steps

  1. Install the PSU cage.
  2. Reconnect the cables to the connectors on the power distribution board.
  3. Install the PSU.
  4. Install the air shroud.
  5. Install the rear support bracket.
  6. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\