Dell PowerEdge XE9685L Installation and Service Manual

PDF

Installing the PSU cage

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the rear support bracket.
  4. Remove the air shroud.
  5. Removing the PSU
  6. Observe and disconnect the cables from the connectors on the power distribution board.
NOTE:Ensure that there are no cables under the PSU cage before installation to prevent the cable from being pinched or crimped.

Steps

  1. Using both hands slowly rotate and pull up the PSU cage handle.
  2. Hold the handle with one hand and the rear side of the PSU cage with the other hand.
  3. Align and insert the PSU cage with the help of guiding slots at both sides of the chassis.
  4. Rotate the handle down to lock position.
    Figure 1. Installing the PSU cage
    This image shows the installation of the PSU cage

Next steps

  1. Connect the cables to the connectors on the power distribution board.
  2. Install the PSU.
  3. Install the air shroud.
  4. Install the rear support bracket.
  5. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\