Dell PowerEdge XE9685L Installation and Service Manual

PDF

Removing the BOSS-N1 module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the rear support bracket.
  4. Remove the air shroud.
  5. Remove the PSU.
  6. Observe and disconnect the cables from the connectors on the power distribution board.
  7. Remove the PSU cage.

Steps

  1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
  2. Slide the BOSS-N1 card carrier out.
    Figure 1. Removing the BOSS-N1 card carrier
    Removing the BOSS-N1 card carrier
  3. Using the Phillips 1 screwdriver removes the M3 x 0.5 x 4.5 mm screw that secures the M.2 SSD to the BOSS-N1 card carrier.
  4. Slide the M.2 SSD out from the BOSS-N1 card carrier.
    Figure 2. Removing the M.2 SSD
    Removing the M.2 SSD
  5. Disconnect the BOSS-N1 power and signal cable from the system board.
  6. Remove the BOSS-N1 power and signal cable from the BOSS-N1 module.
    Figure 3. Removing the BOSS-N1 power and signal cable from the BOSS-N1 module
    Removing the BOSS power cable and BOSS signal cable from the BOSS-N1 module
  7. Using the Phillips 1 screwdriver removes the M3 x 0.5 x 4.5 mm screw that secures the BOSS-N1 module.
  8. Slide the BOSS-N1 module toward the front of the chassis and lift the module.
    Figure 4. Removing the BOSS-N1 module
    This image shows Removing the BOSS-N1 module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\