Dell PowerEdge XE9685L Installation and Service Manual

PDF

Removing the PSU cage

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the rear support bracket.
  4. Remove the air shroud.
  5. Removing the PSU
  6. Observe and disconnect the cables from the connectors on the power distribution board.

Steps

  1. Using both hands slowly rotate the handle and pull up the PSU cage handle.
  2. Hold the handle with one hand and the rear label side with the other hand.
  3. Lift the PSU cage away from the system.
    Figure 1. Removing the PSU cage
    This image shows the removal of the PSU cage.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\