Dell PowerEdge XE9780 Installation and Service Manual

Expansion card riser specifications

The PowerEdge XE9780 system supports up to four PCI express (PCIe) Gen 5 expansion x16 cards that are installed on PCIe Switch Board (PSRBB) for B300 GPU configuration and up to 12 (8 x 75 W, 4 x up to 150 W) Gen5 x16 FHHL cards(PCIe) on PSBB for B200 GPU configuration.

Table 1. Expansion card slots- B300This table provides information about the expansion card slots that are supported on the system.
PlatformLocationProcessor Connection PCIe slot height PCIe slot length PCIe slot width
PSRBB-B300 OCP 3.0 SFF - Slot 1 Processor 1 N/A Half length x16
Slot 3 Processor 1 Full height Half length x16
Slot 6 Processor 1 Full height Half length x16
Slot 9 Processor 0 Full height Half length x16
Slot 12 Processor 0 Full height Half length x16
Table 2. Expansion card slots- B200This table provides information about the expansion card slots that are supported on the system.
Platform Location PCIe slot height PCIe slot length CPU0 - PCIe SW1 CPU0 - PCIe SW2 CPU1 - PCIe SW3 CPU1 - PCIe SW4
RS1 RS2 RS3 RS4
PSBB-B200 OCP 3.0 SFF - Slot 1 N/A Half length N/A N/A N/A x16
Slot 2 Full height Half length N/A N/A N/A x16
Slot 3 Full height Half length N/A N/A N/A x16
Slot 4 Full height Half length N/A N/A N/A x16
Slot 5 Full height Half length N/A N/A x16 N/A
Slot 6 Full height Half length N/A N/A x16 N/A
Slot 7 Full height Half length N/A N/A x16 N/A
Slot 8 Full height Half length N/A x16 N/A N/A
Slot 9 Full height Half length N/A x16 N/A N/A
Slot 10 Full height Half length N/A x16 N/A N/A
Slot 11 Full height Half length x16 N/A N/A N/A
Slot 12 Full height Half length x16 N/A N/A N/A
Slot 13 Full height Half length x16 N/A N/A N/A

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\