Dell PowerEdge XE9780 Installation and Service Manual
Installing the air shroud
Prerequisites
- Follow the safety guidelines listed in the Safety instructions.
- Follow the procedure listed in Before working inside your system.
Steps
Lower the air shroud into the HPM sled and slide the air shroud to the rear of
the HPM sled.Figure 1. Installing the air
shroud 
NOTE:The air shroud hooks must
be engaged with the cable manager on both sides of the HPM sled.
Next steps
- Replace the bus bar power cables.
- Replace the HPM sled cover.
- Replace the HPM sled.
- Follow the procedure listed in After working inside your system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\