Dell PowerEdge XE9780 Installation and Service Manual

PDF

Installing the HPM sled cover

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Ensure that all internal cables are connected and routed properly, and no tools or extra parts are left inside the system.

Steps

  1. Align the tabs on the sled cover with the guide slots on the HPM sled.
  2. Slide the sled cover to the front until it is locked.
    Figure 1. Installing the HPM sled cover
    This image shows how to install the HPM sled cover.
    NOTE:Ensure that the system cover closes without obstruction or unnecessary force. Reseat any cables or components or realign the system cover if necessary.

Next steps

  1. Replace the HPM sled.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\