Dell PowerEdge XE9780 Installation and Service Manual

PDF

Installing the PCIe air shroud

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.

Steps

  1. Align the PCIe air shroud with the PCIe mounting bracket.
  2. Lower the PCIe air shroud into the system until it is firmly seated.
    NOTE:Connect the BOSS-N1 cable, RJ45 connector cable, and OCP cable to the PSBB or PSRBB (PCIe Switch Base Board or PCIe Switch Retimer Base Board.
    Figure 1. Installing the PCIe air shroud
    Installing the side PCIe air shroud.
    NOTE:The procedure to install the left and right PCIe air shroud is the same.
    Figure 2. Installing the middle PCIe air shroud
    Installing the middle PCIe air shroud.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\