Dell PowerEdge XE9780 Installation and Service Manual

PDF

Removing an EDSFF E3.S Gen5 NVMe drive from the drive carrier

Steps

  1. Using a Torx 6 screwdriver, remove the screws from the slide rails on the drive carrier.
    Torx screw image
  2. Lift the drive out of the drive carrier.
    Figure 1. Removing the EDSFF E3.S Gen5 NVMe drive from the drive carrier

    This image shows removing the EDSFF E3.S Gen5 NVMe drive from the drive carrier

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\