Dell PowerEdge XE9780 Installation and Service Manual

PDF

Removing the bus bar power cables

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Remove the HPM sled.
  3. Remove the HPM sled cover.

Steps

Pull the bus bar power cables using the pull-out tabs on cable connectors that connect the PIB and midplane.
Figure 1. Removing the bus bar power cables
Removing the bus bar power cables.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\