Dell PowerEdge XE9780 Installation and Service Manual

PDF

Removing the HPM sled

Prerequisites

Follow the safety guidelines listed in the Safety instructions

Steps

  1. Using Philips 2 screw driver loosen the four front mount captive screws on the chassis and the two captive screws on the CAM levers.
  2. Holding both the CAM levers pull out the HPM sled.
    NOTE:If the sled does not come out, ensure all the shipping screws have been removed. To remove shipping screws, see Removing shipping screws.
    Figure 1. Removing the HPM sled
    This image shows how to removing the front bezel.
  3. Press and slide the white plastic lock on the stab-in rail o the front to disengage the HPM sled from the chassis.
    NOTE:This step is optional and to remove or install the components in the HPM sled it is not mandatory to remove the HPM sled out of the chassis.
    Figure 2. Removing the HPM sled from stab-in rail
    Removing the HPM sled from stab-in rail of the chassis.

Next steps

Replace HPM sled.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\