Dell iDRAC Telemetry Reference Guide

PDF

Disabling Metric Report Definition Using iDRAC UI

The following outlines the steps to disable a Metric Report Definition using the iDRAC web interface (iDRAC UI).

Steps

  1. Go to Configuration > System Settings > Telemetry Configuration > Metric Report Definition.
  2. Go to Actions dropdown > Select Edit Report properties.
  3. Disable the metric report by selecting “Disabled” in Metric Report State and then update the remaining settings as needed.
    NOTE:For more information about how to use the iDRAC UI, click Help on the right corner of the iDRAC UI page. For more information about Metric Report Properties, see Configurable Properties in MRD.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\