Dell iDRAC Telemetry Reference Guide

PDF

View current status of metric injection

To view the status of metric injection, run the following command:

racadm get iDRAC.Telemetry.EnableMetricInjection
NOTE:
  • Only users with iDRAC Admin privileges can enable metric injection.
  • The metric injection feature is only available to OS application via inband using OAuth token.
  • New MetricDefinition (MD) can only be added when MetricInjection is enabled.
  • New MD can be added or deleted and cannot be modified.
  • Currently a maximum of 50 MDs can be injected.
  • The injected MDs will be persisted available after iDRAC reset, similar to MRDs.
  • racresetcfg racadm command removes the injected MDs.
  • Submit metric values is only allowed when Metric Injection is enabled.
  • Submit metric values will be allowed without nonexisting metric id but the report will not have those instances.
  • The report generation and streaming behavior for the injected metrics will be the same as existing reports today.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\