Dell PowerEdge XR4000w Installation and Service Manual

PDF

Installing the witness sled

Prerequisites

Follow the safety guidelines listed in the Safety instructions.

Steps

  1. Align and insert the witness sled into the chassis.
  2. Using the witness sled handle, slide the sled until it locks into place.
    NOTE:The XR4000w (witness) sled in not hot pluggable and the chassis has to be powered off before removing the witness sled. Once power is reapplied to the chassis, the Witness sled must be allowed time to boot. This boot time should be around 5 minutes.
    Figure 1. Installing the witness sled into XR4000r

    This image shows the installing the witness sled from XR4000z chassis.

    Figure 2. Installing the witness sled into XR4000z

    This image shows the installing the witness sled from XR4000z chassis.

Next steps

Connect all the cables and peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\