Dell PowerEdge XR4000w Installation and Service Manual

PDF

Removing the system board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the following components:
    1. Witness sled
    2. M.2 module

Steps

  1. Using a Phillips 2 screwdriver, remove the screws that secure the witness sled system board to the system.
  2. Hold the witness sled system board by the edges and slide it towards the rear. Lift the system board out of the system.
    Figure 1. Removing the system board

    This image shows the removal of the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\