Dell PowerEdge XR4000w Installation and Service Manual
User interfaces: iDRAC
NOTE:A valid Service Tag must be programmed to the Witness, and the CM must have backed up this tag as part of the Witness Easy Restore (FRU recovery) process. Without a valid Service Tag, the iDRAC will not report all Witness information.
The iDRAC of a compute sled that is connected to the same CM as a Witness node has several methods of interacting with or collecting information from the Witness.
Witness node information, status, and power control interfaces are available through the following compute node interfaces:
- iDRAC GUI
- Redfish
- RACADM
More interfaces that provide some Witness data:
- CPLD
- IPMI
NOTE:The XR4000w does not have a dedicated iDRAC interface. All references to iDRAC in this document are from the standpoint of the iDRAC interface that is on any of the installed XR4510c or XR4520c compute sleds.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\