Dell PowerEdge XR4000z Installation and Service Manual

PDF

Installing the power module assembly

Prerequisites

Follow the safety guidelines listed in the Safety instructions.

Steps

  1. Align and insert the power tray along with the power module assembly (PDB) into the chassis.
  2. Using the Phillips 2 screwdriver, tighten the captive screw to secure power tray in to the rear of the chassis.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the power module assembly

    This image shows to install the he power module assembly.

  3. Install the rear cover.

Next steps

Follow the procedure listed in After working inside your system..

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\