Dell PowerEdge XR4000z Installation and Service Manual

PDF

Removing a sled

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Remove the front bezel, if applicable.

Steps

  1. Pull the blue lever on the sled to release the sled handle.
  2. Holding the sled handle, slide the sled out of the enclosure.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    CAUTION:Support the system with both hands while sliding it out of the enclosure.
    Figure 1. Removing a 1U sled from XR4000z
    Removing a sled
    Figure 2. Removing a 2U sled from XR4000z
    Removing a sled

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\