Dell PowerEdge XR4000z Installation and Service Manual

PDF

Removing power module assembly

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Remove the rear cover.
  3. Remove the sleds.
  4. Remove the witness sled.
  5. Remove the power supply units.

Steps

  1. Using a Phillips 2 screwdriver, loosen the captive screw.
  2. Pull the power tray along with the power module assembly (PDB) from the chassis.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    NOTE:Support the power tray with both hands while sliding it out of the chassis.
    NOTE:The Service Tag transfer is required after Power Module Assembly is replaced.
    Figure 1. Removing power module assembly

    This image shows to remove the power module assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\