Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerStore Installation and Service Guide for PowerStore 1000, 1200, 3000, 3200, 5000, 5200, 7000, 9000, and 9200

PDF

Remove a 4-port card

Steps

  1. Remove the SFPs from the front of the embedded module.
  2. Push down the two blue tabs on the back of the 4-port card to release the 4-port card.
    Figure 1. Opening the retaining tabs
    Opening the retaining tabs for the 4 port card.
  3. Lift the 4-port card off the pegs, and pull the 4-port card away from the embedded module.
    NOTE:If you are having difficulty removing the 4-port card, loosen the four captive screws that secure the air dam to the front of the embedded module .
    Figure 2. Removing the 4-port card
    Removing the 4 port card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\