Dell DL4000 Appliance Deployment Guide

PDF

Checking network connectivity

To check network connectivity:
  1. On the client system to which you are trying to connect, open a command line interface.
  2. Run the command ipconfig and note the IP address of the client.
  3. Open a command line interface on the appliance.
  4. Run the command ping <IP address of client>.
  5. Depending on the result, do one of the following:
    • If the client does not reply to the ping, verify the server’s connectivity and network settings.
    • If the client replies, check that the firewall settings allow the Rapid Recovery components to run.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\