Dell DL4000 Appliance Deployment Guide

PDF

Checking the firewall settings

If the client is connected properly to the network, but cannot be seen by the Core Console, check the firewall to ensure that necessary inbound and outbound communications are allowed.

To check the firewall settings on the Rapid Recovery Core and any clients that it backs up:

  1. On the appliance, click Start > Control Panel.
  2. In the Control Panel, click System and Security, under Windows Firewall click Check firewall status.
  3. Click Advanced Settings.
  4. In the Windows Firewall with Advanced Security screen, click Inbound Rules.
  5. Ensure the Rapid Recovery Core and ports display Yes in the Enabled column.
  6. If the rule is not enabled, right-click on the Rapid Recovery Core and select Enable Rule.
  7. Click Outbound Rules and verify the same for Rapid Recovery Core.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\