Dell DL4000 Appliance Deployment Guide

PDF

Configuring SNMP settings

Simple Network Management Protocol (SNMP) is a commonly used network management protocol that allows SNMP-compatible management functions such as device discovery, monitoring, and event generation. SNMP provides network management of the TCP/IP protocol.

To configure SNMP alerts for the appliance:

  1. On the Configure SNMP Settings page, select Configure SNMP on this appliance on the Configure SNMP Settings page.
    NOTE: Deselect Configure SNMP on this appliance if you do not want to set up SNMP details and alerts on the appliance and skip to step 6.
  2. In Communities, enter one or more SNMP community names.
    Use commas to separate multiple community names.
  3. In Accept SNMP packets from these hosts, enter the names of hosts with which the appliance can communicate.
    Separate the host names with commas, or leave blank to allow communication with all hosts.
  4. To configure SNMP alerts, enter the Community Name and the Trap destinations for the SNMP alerts and click Add.
    Repeat this step to add more SNMP addresses.
  5. To remove a configured SNMP address, in Configured SNMP addresses, select the appropriate SNMP address and click Remove.
  6. Click Next.
    The Create Windows and RASR virtual disk(s) page is displayed.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\