Dell DL4000 Appliance Deployment Guide

PDF

Connecting the storage enclosure to the system

Connect the data cable from the PowerEdge RAID Controller (PERC) installed in the Dell DL4000 system to the primary Enclosure Management Module (EMM) SAS In port of the storage enclosure.
Figure 1. Connecting the SAS cable from the DL4000 system to the Powervault MD1200 storage enclosure
This figure shows how to connect the SAS Cable From the DL4000 system to the PowerVault MD1200 storage enclosure.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\