Dell DL4000 Appliance Deployment Guide

PDF

Setting the storage enclosure configuration switch

Set the storage mode for the storage enclosure to unified mode as indicated in the following figure.
NOTE: The configuration switch must be set before turning on the storage enclosure. Changing the configuration mode after turning on the storage enclosure has no effect on enclosure configuration until the system is power cycled. For more information, see the Dell PowerVault MD1200 Hardware Owner's Manual at https://www.dell.com/support.
Figure 1. Setting the PowerVault MD1200 storage enclosure configuration switch
This figure shows the PowerVault MD1200 Storage Enclosure Configuration Switch.
  1. configuration switch

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\