Dell DL4000 Appliance Deployment Guide

PDF

Teaming network adapters

By default, the network adapters (NICs) on the DL4000 Appliance are not bonded, which affects the performance of the system. It is recommended that you team the NICs to a single interface. Teaming the NICs require:
  • Reinstalling the Broadcom Advanced Control Suite
  • Creating the NIC team
  • Configuring a Hyper-V Virtual Switch

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\