Using the alignment posts, place the system board on the
palm-rest and keyboard assembly and align the screw holes on the system board with
the screw holes on the palm-rest assembly [1].
Replace the two screws (M2x3) that secure the system board to the palm-rest and keyboard assembly [2].
Align the screw holes on the Type-C USB bracket with the screw holes on the system board and replace the three screws (M2x4) that secure the Type-C USB bracket to system board [3].
Connect the coin-cell battery cable to the system board [1].
Connect the fingerprint-reader cable to the system board and close the latch [2].
Connect the keyboard-back light cable to the system board and close the latch [3].
Connect the display cable to the system board [4].
Place the display-cable bracket on the system board and replace the two screws (M1.6x1.8) that secure the bracket to the system board [5].
Affix the tape that secures the display-cable bracket to the system board [6].
Connect the camera cable to the system board and close the latch [7].