Precision 7670 Service Manual

PDF

Removing the GPU card

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the base cover.
  3. Remove the heat-sink for discrete graphics.

About this task

The figure indicates the location of the GPU card and provides a visual representation of the removal procedure.

Removing the GPU card

Steps

  1. Carefully pry up the outside-end of the GPU power cable connector head to unlock the GPU power cable connector from the GPU card.
  2. Slightly slide the GPU power cable connector outwards to disconnect the GPU power cable from the GPU card.
  3. Remove the four (M2x6) screws that secure the PCB beam connectors on the system board.
  4. Lift to remove the PCB beam connectors from the system board.
  5. Remove the three (M2x5) screws that secure the GPU card to the system chassis.
  6. Remove the GPU card from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\