Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Precision 3930 Rack Service Manual

Installing the riser 1 dell ultraspeed drive duo card

Steps

  1. Press the release latch on the dell ultraspeed drive duo card cover [1] and lift the cover open [2]. Remove the one (M2x2.5) screw [3].
    To install the M.2 SSD
  2. To install the M.2 SSD
    1. Insert the SSD card into the slot on the module [1], Replace the one (M2x2.5) screw [2] that secures the SSD card and close the module cover [3].
      Installing the riser 1 dell ultra-speed drive duo card
  3. Slide the Dell Ultraspeed Drive Duo Card into the riser 1 slot 2 [1]. Close the riser 1 module release latch [2].
    NOTE Ensure that the Dell Ultraspeed Drive Duo Card bracket is installed correctly in the slot.
    Installing the riser 1 dell ultra-speed drive duo card
  4. Install the:
    1. Riser 1 module
    2. Top cover
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\