- Notes, cautions, and warnings
- Chassis
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Side cover
- Power supply unit (PSU)
- Front bezel
- Hard Disk Drive bezel
- Hard disk drive assembly
- NVMe Flexbay
- Slim Optical Disk Drive
- Front input and output bezel
- Optical Disk Drive
- 5.25 inch ODD bracket
- Front input and output panel
- Input and output panel bracket
- Intrusion switch
- Internal chassis speaker
- Air shroud
- Memory
- Expansion card
- Coin cell battery
- Center System fan/HDD fan
- Fan bracket
- PCIe holder
- Heat sink and CPU fan assembly
- Processor
- Front system fan
- VROC module
- System board
- RAID controller battery
- RAID controller battery bracket
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
Dell Precision 5820 Tower Owner's Manual
Removing the air shroud
- Follow the procedure in Before working inside your computer.
- Remove the side cover
- To remove the air shroud:
- Press in the securing tabs by holding the air shroud from both the ends, and then lift the air shroud from the system.
- Press in the securing tabs by holding the air shroud from both the ends, and then lift the air shroud from the system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\