- Notes, cautions, and warnings
- Chassis
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Power supply unit (PSU)
- Side cover
- Air shroud
- Front bezel
- PCIe holder
- Intrusion switch
- Front system fan assembly
- Internal chassis speaker
- Hard disk drive and the Optical disk drive bezel
- Hard disk drive assembly
- NVMe Flexbay
- Front input and output bezel
- Front input and output panel
- Rear system fan
- Right side cover
- Hard disk drive and optical disk drive frame
- Slim Optical Disk Drive
- 5.25-inch optical drive
- Power distribution and fan control board
- Front HDD cable and fan assembly
- Fan bracket
- Graphical processing unit(GPU)
- Center System fan/HDD fan
- Memory
- Coin cell battery
- Processor heat sink module
- System board
- RAID controller battery
- VROC module
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
Dell Precision 7920 Tower Owner's Manual
Installing the processor heat sink module
- Place the heat sink on the CPU slot.
- Replace the four screws in the diagonal order (1,2,3,4), to secure the heat sink to the system board.
- Install the:
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\