Dell RecoverPoint for Virtual Machines 6.0.1 Installation and Deployment Guide

PDF

Adding VxRail appliances or nodes

Adding a VxRail appliance or node requires verifying the node addition, configuring ESXi nodes, registering the new ESXi clusters, and adjusting VM-host affinity rules.

About this task

After adding a VxRail appliance or a node to an existing appliance:

Steps

  1. Verify that the nodes are added into the same vSAN cluster and under the same vCenter.
  2. Configure each ESXi node with the required data network adapters for enabling splitter-to-vRPA communication.
  3. If you created a new ESXi cluster, register it within the vRPA cluster.
    This action installs the RecoverPoint for VMs splitters on the new ESXi nodes.
  4. Adjust VM-host affinity rules for the vRPAs to ensure that they are running on separate ESXi servers.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\