Dell RecoverPoint for Virtual Machines 6.0.1 Installation and Deployment Guide

PDF

Enable communication between vRPA clusters

Use this procedure to enable communication between pairs of vRPA clusters in your system.

About this task

Use the Connect vRPA clusters wizard in the RecoverPoint for VMs Deployer to add a vRPA cluster to your system, and to enable IP communication between that new cluster and one of the existing clusters. For more information, see Connect vRPA clusters.

Use the following procedure to enable communication between additional pairs of clusters.

Steps

  1. Use an SSH client to connect as admin user to a cluster management vRPA of one of the pair of vRPA clusters between which you want to enable communication.
  2. From the Admin CLI Main Menu, select Cluster operations > Configure connection types to other clusters in the system > Configure cluster connection types.
  3. Select the vRPA cluster with which you want to enable communication.

Results

Bi-directional IP communication is enabled between the designated pair of vRPA clusters.

Repeat this procedure for each pair of vRPA clusters for which you want to enable communication.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\