Dell RecoverPoint for Virtual Machines 6.0.1 Installation and Deployment Guide

PDF

I/O throttling

I/O throttling is used to slow down storage reads that are part of any initialization process including the initial full synchronization (full-sweep).

I/O throttling mitigates the negative impact of initialization on production performance. As a result, however, the initialization process may take longer than expected.

I/O throttling is initially enabled at 400 MBps and is set at the vRPA cluster level.

You can use the config_io_throttling Sysmgmt CLI command to set the I/O throttling setting.

For more information on I/O throttling, see the RecoverPoint for Virtual Machines CLI Reference Guide.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\