Dell RecoverPoint for Virtual Machines 6.0.1 Installation and Deployment Guide

PDF

Register ESX clusters

By default, ESX clusters are registered automatically as part of the Protect VM procedure. Alternatively, you can register ESX clusters manually, using the RecoverPoint for VMs plug-in to the vSphere Client or vSphere Web Client.

Steps

  1. Access the vSphere Client or Web Client.
    In the vSphere Client, click System > ESX Clusters.
    In the vSphere Web Client, click RecoverPoint for VMs Management > Administration > vRPA Clusters, and select the ESXi Clusters tab.
  2. Select the ESX cluster to be registered, and click Add. Verify that the connectivity status is OK. If there are connectivity issues with the cluster, click Troubleshoot.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\