Dell RecoverPoint for Virtual Machines 6.0.1 Installation and Deployment Guide

PDF

Removing custom tokens from the Managed Object Browser

About this task

The custom tokens that correspond to the RecoverPoint for VMs cluster ID need to be removed from the cluster(s) being reinstalled for all previously used vCenters.
NOTE:Access to the Managed Object Browser is disabled by default in vSphere 6.0. For instructions on how to enable access, refer to VMware KB2108405.

Steps

  1. In a web browser, enter the fully-qualified domain name (or IP address) of the vCenter Server system:
    https://<hostname.yourcompany.com>/mob/?moid=CustomFieldsManager
  2. Log in using your vCenter login credentials.
  3. In the Methods table, select RemoveCustomFieldDef.
    A new browser window opens with the void RemoveCustomFieldDef command displayed.
  4. In the Parameters table, enter the value of a custom field listed in the Properties table that corresponds to the Internal cluster name, RecoverPoint_TOKEN, for example, config.RecoverPoint_TOKEN;3070371118132351610.
  5. Click Invoke Method.
  6. If you are reinstalling several clusters, repeat steps 3 through 5 for each custom field listed in the Properties table that corresponds to the Internal cluster names.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\