Dell RecoverPoint for Virtual Machines 6.0.1 Installation and Deployment Guide

Uninstall the RecoverPoint for VMs Splitter and JIRAF

Use the uninstaller.bat tool to uninstall the RecoverPoint for VMs Splitter and JIRAF.

1. Run iof_uninstall.
   This command removes Splitter, and JIRAF IO filters completely from your vCenters and ESXi clusters.
2. A message is displayed Would you like to proceed? (Y/N):
   • Type Y if you want to continue to uninstall Splitter and JIRAF or Type N to stop the uninstallation.
3. Enter the IP address of the vCenter.
4. Enter the TCP port number of vCenter or press Enter for the default port (443).
5. Enter the vCenter username.
6. Enter the vCenter password.
   A message is displayed Checking vCenter connectivity vCenter is ready for scanning, do you want to add a new vCenter? (Y/N) or press Q to quit: .
7. Type N if you do not want to add another vCenter to remove IO Filters or Type Y if you want.
   The scanning ESXi Clusters:

   (1) <Cluster-Name> v

   (2) All

8. Ensure to enter a comma-separated ESXi cluster number (such as 1, 2) / All:
   A message is displayed Do you want to continue uninstallation of IO Filters on selected vCenter(s) and ESXi cluster(s)? (Y/N).
9. Type Y to complete the uninstallation.