SupportAssist Enterprise Version 2.0 Quick Setup Guide

Set up SupportAssist Enterprise for a remote device

1. Point to Devices and click View Devices.
   The Devices page is displayed.
2. Click Add Devices.
   The Add Single Device window is displayed.
3. From the Device Type list, ensure that Server / Hypervisor is selected.
4. Type the IP address or host name of the server in the appropriate field.
   NOTE: Dell recommends that you enter the host name of the server. If the host name is not available, you can enter the IP address of the server.
5. If desired, type a name for the device in the appropriate field.
   The name you enter is used to represent the device in SupportAssist Enterprise. If you do not enter a name, the IP address or host name that you have entered is used to represent the device.
6. From the Account Credentials list, select Create Account, and then click Create.
   The Add Account Credentials window is displayed.
7. In the Name field, type a unique name for the Account Credentials.
8. From the Device Type list, ensure that Server / Hypervisor is selected.
9. From the Operating System type list, select Windows.
10. Enter the user name and password of the remote device in the appropriate fields.
11. Click Save.
12. Click Next.
    The Discovering Device page is displayed until SupportAssist Enterprise identifies the device.

    If the device is discovered successfully, the Assign Device Group page is displayed. Otherwise, an appropriate error message is displayed.

13. If desired, from the Assign Other Group list, select a device group to which you want to assign the device.
14. Click Finish.
    The device is added to the device inventory and the Summary page is displayed.
15. Click OK to close the Add Single Device wizard.