Dell Unity™ Family VNX® Series Data Import to Unity All Flash or Hybrid, or UnityVSA™ System User Guide

Change import session settings for block

Change the settings for a block import session.

/import/session/block –id <value> set [-async] [-name <value>] [-paused {yes | no} [-throttle {yes | no}] [-cutoverThreshold <value>]

Qualifier	Description
-id	Type the ID of the import session.

Qualifier	Description
-async	Run action in asynchronous mode.
-name	Specifies the new name of the import session.
-throttle	Specifies whether to throttle the import transfer. Throttle impacts the import speed and host latency for the related LUNs and file systems that are in use on the source and target storage systems. Valid values are: yes no NOTE: Default is to throttle the import transfer, which means that it is throttled at less than the full speed.
-paused	Specifies whether to pause the import session. Valid values are: yes no NOTE: no starts or resumes the import session.
-cutoverThreshold	Specifies the threshold percentage below which the import session is cutover-ready.

The following command changes the block import session settings for name to newName, the commitThrottle level to 5, and to not apply the throttle:

uemcli -d 10.0.0.1 -u Local/joe -p MyPassword456! /import/session/block –id import_1 set -name newName -throttle no -cutoverThreshold 5

Storage system address: 10.0.0.1
Storage system port: 443
HTTPS connection

Operation completed successfully.