Dell Unity™ Family VNX® Series Data Import to Unity All Flash or Hybrid, or UnityVSA™ System User Guide
Create remote system configurations
Configures a remote system configuration for the local system to access.
NOTE: For a source VNX system with two control stations, the home directory of a user with the Administrator role, which is used in configuring the import connection, must exist on the primary control station of the VNX. See
VNX system with two Control Stations.
Format
/remote/sys create -addr <value> [-type VNX] -srcUsername <value> {-srcPassword <value> | -srcPasswordSecure} -dstUsername <value> {-dstPassword <value> | -dstPasswordSecure} [-connectionType {sync | async | both}]Action qualifiers
| Qualifier | Description |
|---|---|
| -addr | Specify the network name or IP address of the remote system. |
| -type | Specify the remote system type. Valid values are:
|
| -srcUsername | For systems that are the source in a replication, type the username that is used to access the system. |
| -srcPassword | For systems that are the source in a replication, type the user password that is used to access the system. |
| -srcPasswordSecure | Specify the password in secure mode. Once you run the command with this qualifier, you will be asked to type the password separately. |
| -dstUsername | For systems that are the destination in a replication session or VNX in an import session, specify the username that is used to access the system. |
| -dstPassword | For systems that are the destination in a replication session or VNX in an import session, specify the user password that is used to access the system. |
| -dstPasswordSecure | Specify the password in secure mode. Once you run the command with this qualifier, you will be asked to type the password separately. |
| -connectionType | Specify this qualifier to indicate the type of replication connection. Valid values are async, sync, or both. |
Example
The following command creates a remote system configuration with these settings:
- Network address is 10.64.75.10.
- Includes access credentials for when the system is the source or destination.
The configure remote system receives the ID RS_65536:
uemcli -d 10.0.0.1 -u Local/joe -p MyPassword456! /remote/sys create –addr 10.64.75.10 –type VNX -dstUsername admin1 -dstPassword Password789!Storage system address: 10.0.0.1 Storage system port: 443 HTTPS connection ID = RS_65536 Operation completed successfully.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\